top of page

Revo Air Intake System
 Increased HP, Torque and Throttle Response

 

The Revo Air Intake System for the Ford Fiesta ST is a high-performance upgrade, offering gains in both power and torque over the stock system.

Initial flow testing of the OEM system highlighted its restrictiveness. The route from airbox to turbo varies in diameter and convolutions in the pipe cause turbulence, slowing airflow to the turbo. The OEM airbox performed better than expected however restricted power towards the top end of the rev range, especially when coupled with Revo Software.

 

The Revo system is currently the only kit that replaces the rear plastic back-pipe with a one-piece 70mm aluminium pipe, mandrel-bent to ensure no internal restrictions. Automotive-grade silicone couplers connect the system to a Revo 3 stage foam filter with integrated MAF sensor housing for ease of fitment and correct scaling. The kit comes complete with an integrated heat shield that utilises the OEM cold air feed, sectioning off the foam filter from the hot engine bay by sealing itself when the bonnet is closed.

 

Revo recommends this upgrade for anyone running Stage 2 and Stage 3 software to achieve maximum performance, however, Stage 1 has also been optimised to work in conjunction with this Air Intake System upgrade and offers a noticeable intake noise.

FORD FIESTA ST MK7 AIR INTAKE SYSTEM

Tuotenumero: RF032M200100
460,00 €Hinta
  • MORE AIR, LESS RESTRICTION

    The Revo system was tested on a flow bench to highlight the efficiency of the kit in allowing more air to reach the turbo, quickly and with less restriction. The OEM system reached its maximum potential of 300 cubic feet per minute with a restriction of 759.3 mmWg, compared to the Revo system which was able to flow 460 CFM with a restriction of only 688.5 mmWg. This difference allows the engine to still make power at the top of the rev limit when installed with the Revo kit.

     

    MORE POWER & TORQUE

    In house hub dyno testing consistently showed a gain of +8-10 WHP and +10 NM Torque over the OEM system, with more power throughout and increased torque towards the top end of the rev range. This intake coupled with Revo software offers a very noticeable change with enhanced throttle response and a sporty intake note.

bottom of page